Fenix TS2000 Series, Руководство по эксплуатации

Страница: 37 / 58

TS2000 PRINTERS OPERATION MANUAL
[Notes]
●
This command sets the print starting position to the beginning of the line.
●
This command does not affect the line spacing set by ESC 2 or ESC 3.
●
The maximum paper feed amount is 1016 mm {40”}. If the paper feed amount ( n x
line spacing) of more than 1016 mm {40”} is specified, the printer feeds the paper
only 1016 mm {40”}.
●
Every line feed corresponds to the current selected font height (24 dots for Font A
and 16 dots for Font B).
[Reference] ESC 2, ESC 3 .
ESC i
[Name] Full Cut
[Format] ASCII ESC i
Hex 1B 69
Decimal 27 105
[Description] Cuts the paper completely in the current position.
[Notes]
●
If this command is sent without cutter connection the printer enters cutter error status.
●
The interval between each cutting operation must be two seconds or more.
●
When the black mark sensor is set to be effective, the printer feeds paper to (black
mark
±
[(value which is set by GS ( F ) x 0.125mm]) and cuts it. After cutting, it feeds
paper to the position specified by the command GS ( F . See section – Black mark
sensor .
[Reference] GS ( F, ESC m, GS V
ESC j n
[Name] Back feed paper
[Format] ASCII ESC j n
Hex 1B 6A n
Decimal 27 106 n
[Range] <00>H
≤
n
≤
<FF>H
[Description] Back feeds the paper [ n x 0.0625 mm (0.0024”)].
[Notes]
●
This command is only effective when the optical mark sensor is enabled.
●
Allows readjust the paper position when the black mark has surpassed the black
mark sensor, and it is needed back feed paper to prepare the cutting.
ESC m
[Name] Partial Cut
[Format] ASCII ESC m
Hex 1B 6d
Decimal 27 109
[Description] Cuts the paper partially in the current position.
[Notes]
●
If this command is sent without cutter connection the printer enters cutter error
status.
●
The interval between each cutting operation must be two seconds or more.
●
This command performs the partial cut even when the black mark is enabled, but no
action relative to black mark is performed.
[Reference] ESC i, GS V.
ESC t n
[Name] Selects the character tables
[Format] ASCII ESC t n
Hex 1B 74 n
Decimal 27 116 n
[Range] <00>H
≤
n
≤
<03>H, <30>H
≤
n
≤
<33>H
[Description] Selects the character tables between the internal ones or the external ones loaded.
37/58