14
EN
5
ACCESSORIES
5.1
CHOISE OF BLADE
Your sawing machine is equipped with a bi-metal blade
measuring 2140x19x0.9 mm with variable toothing 6/10
teeth per inch, for use in the majority of cuts possible with
this machine.
For special requirements (see cutting table ), for example,
for cutting large solid sections or profiled sections or corner
pieces of small thickness, there are also blades avail-able
with 4/6 toothing or 14 teeth per inch.
MATERIAL: .............. M42 (steel for s steel HSS)
EXTENSION: .................................................... mm 2140
HEIGHT: ............................................................... mm 19
THICKNESS: ...................................................... mm 0,9
TOOTHING: .............................................. standard 6/10
.............................................................. optional 4/6 - 14
6
MAINTENANCE
6.1
ROUTINE MAINTENANCE
The interventions of routine maintenance which can also
be carried out by unskilled personnel are described in this
paragraph and in the previous ones.
WARNING:
Before any maintenance work, disconnect the
machine plug from the mains.
WARNING:
During the maintenance works, always wear
protective gears (protective goggles and gloves
of adequate size).
AFTER EVERY USE
• If need be, remove any chip in the cutting area and on
the sawblade guides. We recommend the use of a brush
or an exhaust fan.
WARNING:
The use of compressed air is absolutely
prohibited !!!
• Check for the correct height of suction of the pump from
the tank and make sure that the coolant comes out from
both dispensers placed on the sawblade guides.
If the thickness of the profiled section is to be very thin,
an outline should be fitted which copies the profile inside
the profiled section itself to stop it being crushed between
the jaws.
4.7
CUTTING CAPACITY
The table below specifies the cutting capacity at 90, 45
and 60 degrees which may be obtained in normal conditions
of use described in this manual and without placing any
other object between the jaws of the clamp.
4.8
CUTTING TABLE
90 gradi
45 gradi
60 gradi
170
170 x 170
190 x 130
110
110 x 110
150 x 110
75
75 x 75
100 x 75
Angle
Cutting capacity
(mm)
Section
Common
and special
steel
Aluminium
and alloy
Brass-
bronze
Stainless
steel
Iron tubing
Profiles
Material
S
(mm)
Section
Z/1”
Mt/Min
MF TF
Nr
MF TF
< 50
> 50
< 50
> 50
< 50
> 50
< 3
> 3<30
>30
< 3
> 3<30
>30
6/10
4/6
6/10
4/6
6/10
4/6
14
6/10
4/6
14
6/10
4/6
50
60
40
30
60
60
60
60
30
30
30
30
60
60
50
60
40
30
60
60
50
60
40
30
4
2
3
1
6
2
6
2
1
1
1
1
6
2
4
2
3
1
6
2
4
2
3
1
s
s
s
s
