Fema M Series, Руководство пользователя, Страница: 30 / 36

FEMA ELECTRÓNICA . SERIES M . M60-LC
30
2. Output and control modules
2.1 Module R1
For additional information:
http://fema.es/docs/4254_SERIES_M-K-S_OPTIONS_manual_en.pdf
Type of relay 3 contacts (Com, NO, NC)
Max. current 8 A (resistive load)
Voltage 250 Vac continuous
Isolation 3500 Veff
Type of terminal plug-in screw terminal, pitch 5.08 mm
Installation allowed at Opt.1, Opt.2, Opt.3
2.2 Module T1
For additional information:
http://fema.es/docs/4254_SERIES_M-K-S_OPTIONS_manual_en.pdf
Type of output transistor
Max. voltage 35 Vdc
Max. current 50 mA
Isolation 3500 Veff
Type of terminal plug-in screw terminal, pitch 5.08 mm
Installation allowed at Opt.1, Opt.2, Opt.3
‘com’ (‘A’)
‘NC’ (‘C’)
‘NO’ (‘B’)
Figure 14 - Detail of the ‘R1’ module and internal scheme
Power
Opt.2
Opt.1
Op
t.3
A B C
A B C
Signal
A B C
A Common
B NO (Normally Open)
C NC (Normally Closed)
Figure 15 - Connections for ‘R1’ relay module
‘B’
‘A’
Figure 16 - Detail of the ‘T1’ module and internal scheme
Power
Opt.2
Opt.1
Op
t.3
A B C
A B C
Signal
A B C
A Emitter
B Collector
C Not connected
Figure 17 - Connections for ‘T1’ transistor module
The R1 module provides 1 relay output, to install on Series
M meters, up to a maximum of 3 relay outputs in the same
meter (for more than 3 relays, see special modules R2, R4 and
R6 at section 2.8).
Configuration from the front key pad, through the alarms
menu of each instrument. For more information see the
‘alarm’ section at the user’s manual.
Relay with 3 contacts (common, normally closed, normally
open) swishing up to 250V @8A.
The R1 modules can be supplied already installed into a Series
M panel meter or as a standalone module. The installation
requires no soldering or special configuration.
The T1 module provides 1 transistor output, to install on Se -
ries M meters, up to a maximum of 3 transistor outputs in the
same meter.
Configuration from the front key pad, through the alarms
menu of each instrument. For more information see the
‘alarm’ section at the user’s manual.
Optocoupled output, 2 terminals, switching up to 35V
@50mA.
The T1 modules can be supplied already installed into a Series
M panel meter or as a standalone module. The installation
requires no soldering or special configuration.