Felton TATE, Руководство по установке

Страница: 18 / 24

18
FELTON
WALL MOUNTED SPOUT INSTALLATION
Measure and cut 1/2” BSP thread to the
desired length
keeping 20-25mm clearance
from the wall for the spout connection (use
fig 2 as reference).
After applying the appropriate sealer to the
thread, hand tighten the 1/2” BSP thread into
the wingback.
2B.
PARALLEL
1.
WINGBACK
90°
FIG 1.
2A.
FIG 3.
Fit the Spout Base onto the 1/2” BSP thread.
Check the o-ring is in place and thread the flange of the bath spout
onto the 1/2” BSP.
Ensure the base fits tightly and firmly against the wall and seals.
3A.
Fit the spout onto the base, ensuring the sleeve stays on the spout and
secure both grub screws using a 2.5mm allen key (not supplied). 4A.
Fit Spout
secure grub screws
4B. Fit the cover sleeve.
Fit Sleeve
5. Connect spout to digital mixer.
Turn on the water supply, operate the mixer and check for leaks.
Fit Spout Base
3B.
20-25MM
Front of wall
FIG. 2
1. Remove the cover sleeve ensuring that it stays on the spout
Loosen the 2x Grub Screws
Remove the spout from the Spout Base
Ensure the wingback when
fitted is parallel and square to
the finished wall lining as shown
(fig. 1)
.
2.