www.felixprinters.com
Page
32
of
65
1.
Mount the power supply to the frame
2.
Label all cables
3.
Place as much cables as possible to the electronics board.
4.
Connect the y-axis table wires to the board.
5.
Connect the opto sensors
6.
Connect the motor wires
7.
Connect the rest of the wires
8.
Clean it up and place the wires into the frame and cable spiral.
This section will walk through the above steps
10.1
Mount the powersupply.
BOM Electronics
Part description
Amount
powersupply_bracket_pt5
1
powersupply_bracket_pt4
1
ramps_case_pt1_v2
1
ramps_case_pt2_v2
1
ramps_support
2
RAMPS + a steppers fully assembled
1
mini-ATX-seasonic
1
Power Cable NL,USA,Australian or British
1
Fan 40x40x10mm
3
heatsinks 10*8
4
precrimped cables 4 threads
4
precrimped cables 3 threads
3
USB cable 1.8m
1
heatshrinks large 50 cm
1
Heatshrinks small 15 cm
4
Get the parts described in the table above.
Place the plastic parts onto the powersupply with the powersupply
screws. The head on the screws may look different than on the picture,
but they have a phillips head and a courser non metric thread with a
length of 6mm and diameter of 3.3mm
