Felix Storch Pro 3, Быстрый старт

Страница: 24 / 28

Quick Start Guide FELIX Pro 3
Page
23
TIP: Clean hot-end exterior from filament before starting a print, to prevent blobs of plastic on your printed
object.
Dust cleaners
Filament attracts a lot of dust and small particles. Make sure the filament enters the filament holder
through the dust cleaner. After a few months of printing it is recommended to replace the dust cleaners.
Motion system
The linear bearings require almost no maintenance. Recommended is that you put a little some grease on
them every 3-4 months.
The belt tension of the x and y axis can also be checked in intervals of 3 months. Check this small movie to
see how to tension the belts.
https://www.youtube.com/watch?v=dpS6nWn5rE8