www.felixprinters.com
Page
47
of
70
15
CALIBRATION OF TABLE (5-15 MINS)
For a successful print it is important that the table is properly calibrated, which means it should be level. The table can be leveled by turning the 3
M4 nuts underneath the heated bed.
!!The calibration is done by moving the axes by hand, not via interface of computer!!
Step 1:
Calibrate the table in y-direction.
1.
Move the X-axis carriage(extruder) to the homing sensor
2.
Move the Y-axis (heated bed) to the homing sensor
3.
Move the table up until approximately 1mm from the hot-end.
4.
Goal is to move the y-axis and to get the distance between the tip of hot-end and the heated bed the same over the whole movement.
5.
Move the bed over the hole movement range and while moving adjust the 2 adjustment nuts underneath the plastic parts under the table
along the rail to level out the table in y-direction.
6.
Move the table a little closer to the hot-end and repeat the previous step until the distance is the same over the whole length.
Step 2:
Calibration in x-direction
7.
Move the table to the middle of its movement range
8.
Move the X-axis carriage over it’s movement range. While moving check the distance between the hot-end and bed. If the distance is not even,
adjust it with the nut which supports the middle of the table.
You are done-calibrating the table.
Right or left view of table
Top view of table
y-direction
y-
dire
ctio
n
Front view of table
Top view of table
y-direction
x-direction