www.felixprinters.com
Page
41
of
70
Guide the cables of the z-axis table like indicated above. Make sure the
wires are mounted to the small aluminum beam as indicated above. This
provides tension relieve to the wires.
Make a loop as indicated above. Make sure that when moving the table
from one side to the loop is just long enough. Make use of cable ties to
better form the loop. They can easily be removed later on.
Guide the cables of the foil-heater along as shown above. Wrap a cable-
tie around it to again provide tension relieve on the cable.
Cut off a piece of 14 cm of frame strip.
Make a second loop and guide it as shown above. This loop is necessary
to let the table move up and down. Again make use of the cable ties to
form the loop.