www.felixprinters.com
Page
39
of
70
Mount the powersupply assembly onto the frame with m4x16 bolts
including washers.
Before mounting the electronics make sure the potmeters are set ok. The
pot-meters shown in the figure above regulate the power to the motors.
The pot meters have a turning range. Fully counter clockwise is full power
to the stepper drivers. Fully clockwise is no-power to the stepper drivers.
Be carefull with turning the potmeter to full power. Over time the stepper
drivers may become too hot. There is a self protection mechanism in the
chip which will temporarily turn the chip off to cool itself down. It will
protect itself, but this is off course unwanted behavior as it will give
intermittent movement during printing. Do the following as a starting
point. If this occurs, then lower the power.
Slide the electronics box in like displayed above.
no-power
full-power
40mm