Felisatti SCF 184/1400, Руководство по эксплуатации

Страница: 6 / 40

6
Circular saw SCF184/1400
Voltage V~ 230
Frequency Hz 50-60
Input power W 1400
No-load speed min
-1
3800
Saw blade diameter mm 184
Max./min. saw blade diameter mm 184/170
Max./min. set width mm 2.5/2.1
Saw blade hole diameter mm 16
Depth of cut at 90º mm 65
Depth of cut at 45º mm 46
Depth setting mm 0-65
Inclination setting 0-45º
Weight according EPTA-Procedure 01/2003 kg 5.3
TECHNICAL DATA
Read the operating instructions
Protection category II power tool; double
insulated
In accordance with essential applicable safety
standards of European directives
In accordance with essential applicable safety
standards of Russian Federation
Wear eye protection
Wear ear protection
Follow very carefully the instructions in this manual,
save it and keep it close at hand, ready to carry out any
inspection of parts that may be necessary.
If the tool is used with care and normal maintenance is
carried out, it will work well for a long time.
The functions and use of the tool you have bought
shall be only those described in this manual. Any other
use of the tool is strictly forbidden.
ILLUSTRATIONS
DESCRIPTION (See figures)
A On/off switch. (Fig. 2)
B Mobile blade guard (Fig. 1)
C Saw blade setting disc (Fig. 1)
D Disc setting screw (Fig. 1)
E Splitting wedge (Fig. 1)
F Depth setting wing nut (Fig. 2)
G Lateral stop setting wing nut (Fig. 3)
H Lateral depth stop (Fig. 1)
I Switch safety knob (Fig. 2)
J Angular cutting wing nut (Fig. 3)
K Cutting line guide (Fig. 3)
L H.M. saw blade (Fig. 1)
M Machine setting wing nut (Fig.1)
N Splitting wedge setting screw (Fig. 1)
O Saw blade upper fixed protection (Fig.3)
EQUIPMENT
- 1 lateral stop
- 1 hexagonal key
- 1 H.M. saw blade
- Operating instructions
- Safety instructions
- Warranty
BRIEF DESCRIPTION
This tool is specially designed for straight sawing
only of boards made from wood and derivatives (plywood,
chipboard etc.).
BEFORE USING THIS TOOL
Before using the tool, make sure the mains voltage
is correct: it must be the same as that on the specification
label. Machines with 230V can also be connected to a 220-
V mains supply.
Before plugging in the tool, always make sure the
control switch A works properly and returns to the OFF
position when released.
START UP
WARNING! Only plug in when machine is switched
off.
Press the locking button I, and squeeze the trigger in
the on/off switch A. When the on/off switch is released, the
machine stops.
FITTING THE DISC
WARNING! Always unplug the machine before
carrying out any work on it.
CAUTION. Do not use bent or cracked blades or