
V. Notice
:
1.
The grinding machine is made in three phase, 220V 20AMP, with the frequency of 60/50
Hz. Please use an independent socket instead of a multi-plug socket. Please also use a
voltage stabilizer to avoid the un-stabilized voltage causing the motor out of order.
2.
Before connecting No Fuse Breaker, please remove the front cap and the rotating disc.
Make sure that the fixed grinding disc is rotated counterclockwise.
3.
Turn on the machine before pouring roasted nuts into the hopper. If users pour into nuts
before the auger functions, it may cause the auger stuck with the nuts. Users should turn
off immediately the power and disassemble the parts for cleaning.
4.
The lack of oiliness contained in the nuts and unroasted nuts are the main causes of lower
butter fluidity, which can cause the motor stuck. If the motor is stuck, turn off
immediately the power and dismantle the parts following the suggested steps for cleaning.
5.
If the motor was over-heated, the Auto Turn-off Safety Device would be activated to
turn off the machine. After the grinder cools down, turn on the power and the grinder
would work normally.
6.
If the auger and the grinding discs were stuck with ingredients, the Over-Current Safety
black button located on the back of the grinder would pop out automatically. Please switch
off the power and pull out the plug. Dismantle the parts for cleaning. After cleaning, press
the Over-Current Safety Device black button located on the back of the grinder. Once
the power is on, the grinder would be working normally.
7.
Please shred nuts that are in big size (almond, walnut, cashew, etc.) or press the nuts in
the hopper with the given wooden rod while grinding.
8.
It is not suitable to grind ingredients that do not contain oiliness (like rice) or that are
rich in liquid (like watermelon) or contains lots of fiber (like old ginger).
9.
If the power cord was damaged, contact the supplier or the distributor for a dedicated
cord.
10.
In the case when the fineness of the paste gets thicker, the butter contains less oil or
the front cap gets hotter than before, check the condition of the grinding discs with the
given Grinding Disc Diagnostics document.
11.
During the operating of the grinder, do not touch the auger with fingers or hard tools, but
only with the given wooden rod.
12.
To avoid water seeping into the motor, do not splash water on the machine and do not pour
water or oil into the hopper.
13.
To avoid scratches on the machine during transportations, a transparent film is stuck on
the machine shell for shipments. Users should remove the transparent film before turning
on the machine for the first time. The exhausting holes on the machine shell should be
un-covered while the machine is in operation.
14.
Before turning on the machine, tighten the funnel securing knobs, because the loosen
funnel securing knobs would make an abnormal loud noise.
Содержание NBM-500
Страница 1: ......