39
FS 700 K
Setup and installation
1
2
3
4
Fig. 21: Position support table
1 Adjusting nuts 1
2 Adjusting nuts 2
3 Idle roller
4 Locking nut
The idle roller rotates in the centre of the table recess.
Table rubs against the idle roller.
1.
Position the support table in such a way that the idle roller
rotates in the centre of the table recess.
7.
Tighten all of the nuts.
7.4
Attach the dust extraction hose
Dust extraction system requirements
Every machine that uses an extraction system shall be extracted in accordance
with EN 12779:2015 or EN 16770:2018.
●
The extraction performance must be sufficient to achieve the negative pres-
sure and air speed required at the connection point (see technical data or
layout).
●
Check extraction power before initial start-up and after significant changes
(to the machine and / or extraction system).
●
Before the machine is put into operation for the first time the dust extraction
setup must be checked. Check for obvious defects on a daily basis and the
efficiency on a monthly basis.
●
The dust extractor must be connected to the machine in such a manner that it
runs in unison with the machine.
Содержание FS 700 K
Страница 6: ...6 Table of contents...
Страница 59: ...59 FS 700 K Use 4 Switch machine on...
Страница 75: ......
