5
WWW.FEIT.COM
Removing the Back Plate
□
Using a Phillips screwdriver, remove the screw located
in the bottom of the flood light (AA). Push the back plate
downward and slide it off.
1
Positioning the Back Plate
□
Identify a mounting location. Place the back plate in the
mounting location with the wide side of the built-in
ridge at the top and hold while marking the holes in
your desired location with a pencil.
2
Installing the Back Plate
□
Drill 4 holes at the marked locations. Insert 4 anchors
(EE). Align the back plate (built-in wide ridge at the top)
with the screw anchors and hold. Attach mounting plate
using 4 fixture mounting screws (DD).
3
Installing the Flood Light
□
Align the flood light (AA) above the backplate. Insert the
molding that is on the back of the flood light (AA) into
the ridge located on the top of the back plate. Slide
downward until the flood light (AA) locks into the
back plate. Using a Phillips screwdriver, insert the flood
light (AA) screw into the bottom of the flood light (AA)
and tighten by rotating clockwise.
4
Security Light Installation
AA
DD
EE
IMPORTANT:
Remove the battery pull tab
to allow operation.
