
locking tabs and remove from pod.
3. Install new light and reassemble panel.
High Beam Headlight Adjustment
The headlight beam can be adjusted up and down.
1. Place the vehicle on a level surface with the headlight approximately 25 ft. (7.6 m)
from a wall.
2. Measure the distance from the floor to the center of the headlight and make a mark
on the wall at the same height.
3. Start the engine and turn the headlight switch to high beam.
4. Observe headlight aim. The most intense part of the headlight beam should be
aimed 2 inches (51 mm) below the mark placed on the wall in step 2.
NOTE:
Rider weight must be included on the seat.
5. Loosen pivot bolt and adjust beam to desired position.
6. Tighten nut and bolt.
Cleaning Your ATV
Keeping your ATV clean will extend the life of various components.
Washing
Never use a high pressure type car wash system, it can damage the wheel bearings,
transmission seals, body panels, brakes and warning labels, and water might enter the
engine or exhaust system.
The best and safest way to clean your ATV is with a garden hose and a pail of mild
soap and water. Use a professional type washing mitten, cleaning the upper body first
and lower parts last. Rinse with water frequently and dry with a chamois to prevent
water spots.
Содержание FAAT6000
