6
Turning your headphones on and off
Turning on the headphones
Press and hold the
MFB
until
the LED indicator
flashes
solid blue for 1 second and then flashes blue and red alternatively with an
ascending “beep” sound heard. The headphones enters into pairing mode (see below) automatically.
Turning off the headphones
Press and hold the
MFB for 4 seconds
until
the LED indicator flash solid red then turn off with a decreasing “beep” sound heard. Atten-
tion: If you will not use the headphones for a while, you should consider turning off the Bluetooth function on your mobile phone as well.
Pairing your headphones
The headphones works with Bluetooth-enabled devices like mobile phones, tablets, notebooks and audio transmitters. Prior to using
and pairing your headphones for the first time, please check if your device is Bluetooth-enabled. Make sure that any devices you have
previously paired to are either powered off or Bluetooth disabled.
The headphones pairing procedure may vary depending on the setting of your device. In case of doubt, please follow the instruction
manual of your device or contact the dealer or manufacturer for further information.
Pairing procedures
Place the headphones and the audio device where they are easily viewable and no more than one meter apart.
Ensure the headphones is turned off.
Press and hold the MFB until the connection LED indicator flashes red and blue alternatively.
Activate your device’s Bluetooth function; please refer to your user guide for details.
Set the mobile phone to search for Bluetooth devices within range and select “FeinSound1” from the list of devices shown. Enter
pass code “0000” and press “OK” to pair your headphones with mobile phone.
If you use a Bluetooth transmitter, set it to pairing mode and wait until both devices are paired. For this type of transmitting device
a pass code is not required.
When the pairing is completed, the LED indicator will flash blue once every 3 seconds and the headphones enters into standby
mode.
Dual Link Pairing
FeinSound1 can be paired with two Bluetooth devices / smartphones at the same time. If FeinSound1 was previously paired to a
smartphone, it is possible to be paired with a 2nd device: restart FeinSound1 (switch off and switch on) to enter pairing mode; repeat
the above pairing procedure to pair FeinSound1 with the 2nd device; and then reconnect FeinSound1 with 1st Smartphone; finally two
devices can connect with FeinSound1.
Audio playback from both devices at once is not allowed. To switch audio playback from one device to the other, stop playback eg. on
one phone and start playback on the other.
After initial pairing is established, the headphones will automatically reconnect to the last paired device upon turning on. Some
transmitting devices may not support the auto-reconnect feature or Dual Link pairing. Please refer to the user manual and check
functionality.
Cancel the Pairing Status
In standby status, turn off the Bluetooth function of your mobile phone. The headphones needs to be re-paired with your mobile phone
after power on again.
Connect with the Last Paired Device
The headphones will connect automatically with the last paired device when switched on. If the reconnection is successful, the LED
indicator will flash blue every 3 seconds. If the connection cannot be completed within 10 minutes, the headphones will turn into
standby mode.
Set back to default Setting:
First make sure the FeinSound1 headphones is turn off. Then press the MFB button (3) for about 10 seconds until the LED (1) flashes
red and blue together and you hear a beep sound twice. The paring memory is erased.
