Fein WSG10-115T, Руководство пользователя

Страница: 27 / 116

27
en
Please note: The angle grinder does not start up:
– when the switchpads at the front and rear are pressed
at the same time
– when the rapid-clamping lever is not tilted back and
engaged
– if one or more of the pressing surfaces is/are pressed
while the mains plug is inserted
Operation:
Only keep one of the 4 pressing surfaces perma-
nently pressed. The angle grinder remains at
working speed.
Notes: The switchpads actuate easily in order to prevent
tense working postures. Changing the working posture is
possible at any time by changing the switching position.
The angle grinder can be brought up to the working
speed again within 1.5 seconds by pressing one of the
4 switchpads.
The
self-start lock prevents the angle grinder from auto-
matically restarting again, even after a brief interruption
of the power supply, e. g., from a pulled mains plug.
Repair and customer service.
When working metal under extreme operat-
ing conditions, it is possible for conductive
dust to settle in the interior of the power
tool. The total insulation of the power tool can be
impaired. Blow out the interior of the power tool via the
ventilation slots frequently with dry and oil-free com-
pressed air, and connect a residual current device (RCD)
on the line side.
WSS14-125T: Unscrew the clamping unit by hand to
protect it from damage and dirt.
If the supply cord of this power tool is damaged it must
be replaced by a specially prepared cord available
through the FEIN customer service centre.
If required, you can change the following parts yourself:
Application tools, auxiliary handle, clamping unit or
flanges, wheel guard (WSG14-150T, WSG14-70ET).
Warranty and liability.
The warranty for the product is valid in accordance with
the legal regulations in the country where it is marketed.
In addition, FEIN also provides a guarantee in accordance
with the FEIN manufacturer’s warranty declaration.
The delivery scope of your power tool may include only
a part of the accessories described or shown in this
instruction manual.
Declaration of conformity.
FEIN declares itself solely responsible for this product
conforming with the relevant provisions given on the last
page of this Instruction Manual.
Technical documents at: C. & E. FEIN GmbH, EGZ,
D-73529 Schwäbisch Gmünd
Environmental protection, disposal.
Packaging, worn out power tools and accessories should
be sorted for environment-friendly recycling.
Selection of accessories
(see pages 13
– 16).
Use only original FEIN accessories. The accessories must
be intended for the power tool type.
A
Grinding disc, flap disc
(use only with mounted wheel guard)
B Cut-off disc
(use only with mounted cut-off wheel guard)
C Steel wire brush, fleece backing pad
(use only with mounted wheel guard)
D Backing pad for fibre sanding sheets, fibre sanding
sheets
(mount only with the provided backing-pad clamp-
ing unit; use only with mounted hand guard or wheel
guard)
E Steel tapered twist brush
(use only with mounted wheel guard)
F Backing pad with Velcro, Velcro sanding sheets,
sanding fleece with Velcro attachment, sponges
(use only with mounted hand guard)
G Steel cup brush, round twist brushes
(use only with mounted hand guard)
H Extraction nozzle for fibre sanding sheets
I Protective suction hood for grinding discs
3 41 01 122 06 0.book Seite 27 Montag, 29. August 2011 3:38 15