20
en
Working instructions.
Before mounting or replacing application tools or accessories, remove the
battery.
This preventive safety measure rules out the danger of injuries
through accidental starting of the power tool.
Do not use accessories not specifically intended and recommended for this power tool by
FEIN.
The use of non-original FEIN accessories can lead to overheating of the power tool
and destroy it.
For each job, use only the FEIN application tool released and intended for
the respective application.
Switching on and off (figure 8).
Always hold the power tool
firmly.
Otherwise, you could
lose control over the power tool.
Guide the power tool toward the work
piece only when switched on.
The self-start prevention lock prevents the
power tool from automatically starting
when the battery is inserted while the on/off
switch is set to on.
If the power tool shuts off without the
switch being actuated, switch the power
tool switch off, remove the battery and reat-
tach it.
Switching on:
Push the switch toward the front
(I)
.
Switching off:
Push the switch toward the rear
(
)
.
Setting the oscillating frequency
(figure 9).
Adjust the oscillating frequency infinitely
variable with the dial control.
Increasing the oscillating frequency:
Turn the dial control in clockwise direction.
Decreasing the oscillating frequency:
Turn the dial control in counterclockwise
direction.
WARNING
CAUTION
CAUTION
Fig. 8
On/Off switch
1
2
3
4
5
6
Fig. 9
Thumbwheel for pre-selection
of oscillating frequency
