15
en
Noise emission values.
Repair and customer service.
Repairs may be carried out only by qualified per-
sons in conformity with the valid regulations.
For repairs, we recommend our FEIN customer service
centre, the FEIN authorised service centres and FEIN
agencies.
When the machine's power supply cable is damaged, it
must be replaced using a specially prepared power supply
cable, available from your FEIN customer service agent.
The current spare parts list of this machine can be found
on the Internet under www.fein.com.
Daily maintenance
Blow out the ventilation slots (18) at the motor
housing and the marked locations with compressed
air (see Instruction label (27)).
Lubricate the machine daily (when in use) with
machine oil at the locations marked (see Instruc-
tion label (27)).
Check the drive disc (23) and the contact disc (21) for
wear and damage each time when replacing a grinding
belt. Have damaged parts replaced.
Loosen star-knob bolt (11).
Remove the chip/grinding-dust box (8) and dispose of
the metal dust.
Before emptying, the contents of the chip/grinding-dust
box must have cooled down sufficiently and may only be
disposed of in suitable containers.
Mount the emptied chip/grinding-dust box again and set
the gap clearance of the grinding rest. (figure 1)
Tighten star-knob bolt (11).
Cleaning the exterior of the machine with compressed
air.
Lubricate the bearings of the tensioning device monthly
via the lubricating nipple (24).
If required, you can change the following parts yourself:
Grinding belt, spark guard
Warranty and liability.
The warranty for the product is valid in accordance with
the legal regulations in the country where it is marketed.
In addition, FEIN also provides a guarantee in accordance
with the FEIN manufacturer’s warranty declaration.
The delivery scope of your machine may include only a
part of the accessories described or shown in this instruc-
tion manual.
Declaration of conformity.
FEIN declares itself solely responsible for this product
conforming with the relevant provisions given on the last
page of this Instruction Manual.
Technical documents at: C. & E. Fein GmbH,
C-D1_IA, D-73529 Schwäbisch Gmünd
Environmental protection, disposal.
Packaging, worn out machines and accessories should be
sorted for environment-friendly recycling.
Connection diagrams.
Type
GI75, GI150
Page 104
Type
GI75 2V, GI150 2V
Page 105
Type
GI75 2H, GI150 2H
Page 106
Type
GI75 2H2V, GI150 2H2V
Page 107
Idle
Sanding
A-weighted emission
pressure power level
measured at the work-
place L
pA
(re 20 μPa), in
decibels
80,5
94
Measuring uncertainty
K
pA
, in decibels
4
4
Measured A-weighted
sound power level L
wA
(re 1 pW), in decibels
90
100,5
Measuring uncertainty
K
wA
, in decibels
2,5
2,5
Operating conditions
Speed (rpm)
3 000
3 000
Material
–
ST 37
Dimension
–
8 x 40
Grinding belt
–
GRIT by Fein
36Z
REMARK: The sum of the measured emission value and
respective measuring inaccuracy represents the upper
limit of the values that can occur during measuring.
Wear hearing protection!
Measured values determined in accordance with the cor-
responding product standard (see last page in this Instruc-
tion Manual).
OBJ_BUCH-0000000317-001.book Page 15 Tuesday, July 10, 2018 9:45 AM
