Manual
VEK S4
FEIG ELECTRONIC GmbH
03/09
23
8
Standard equipment, accessories
The
single unit
includes four 4-pole plug terminals. This allows you to make all the connections including
the serial interface.
For larger systems the connection between the detectors is generally made using a ribbon cable. Therefore
the
10-pack
includes only the terminals for the loop connections. Additional connection parts must be
ordered depending on which connection option is selected.
What you need:
•
For connecting multiple detectors together a 10-pole ribbon cable with a corresponding number of spring
action contacts
•
For the supply voltage and communications interface either a plug terminal or a longer ribbon cable per
system
•
If using the open collector outputs an additional plug terminal per detector
The following accessory sets are available:
8.1 VEK M4D – connection kit
Contents: 4 plug terminals, configured 1m ribbon cable with 16 spring action contacts and an additional
spring action contact
The ribbon cable is trimmed to length by the user for the number of detectors. If the power is provided
through the plug terminals this set allows you to equip e.g. 4 systems with 4 detectors each. Using the
additional spring action contact you can alternatively provide power directly through the ribbon cable.
Additional plug terminals are required if using the detector outputs!
8.2 VEK M4D accessories, 10 screwless terminals
For additional connections or as a spare part for the loop connections
8.3 Service
software
The traffic detector can be parameterised using the
S4Com
service program. As the VEK S4 is downwards
compatible and supports the interface protocols of the VEK S3, the
S3ComWin
service program can also be
used. Please pay attention here to the special features of the addressing.
Æ
4.5.1 Device address
Note:
In order to avoid bus conflicts, the host computer must be disconnected from the RS485 bus while the
service program is being used.
