TST
Startup
FU3E
FEIG ELECTRONIC GmbH
Page 29 of 29
FU3E_Inbetriebnahme_7_GB.doc
I.202
Reference position missing
I.203
Reference position incorrect
I.205
Synchronization
I.210
Pre-limit switch Upper not plausible
I.211
Pre-limit switch Lower not possible
I.310
Open-command on Door2 being issued
I.500
Correction of upper limit switch running
I.501
Upper pre-limit switch corrected
I.502
Upper limit switch band corrected
I.505
Correction of lower limit switch running
I.506
Lower pre-limit switch corrected
I.507
Lower limit switch band corrected
I.510
Limit switch correction finished
I.515
Controller is preparing automatic teach-in of the limit switches
I.520
Maximum speed during automatic limit switch correction is not reached
I.555
Limit switches being corrected
Information messages while parameterizing
noEr
Error memory: no error saved
Er--
Error memory: if error but no associated message found
Prog
Programming message while carrying out original parameter or default set
General inputs
E.000
OPEN key on membrane keypad
E.050
STOP key on membrane keypad
E.090
CLOSE key on membrane keypad
E.101
Input 1
E.102
Input 2
E.103
Input 3
E.104
Input 4
E.105
Input 5
E.106
Input 6
E.107
Input 7
E.108
Input 8
E.109
Input 9
E.110
Input 10
E.121
Input 21
E.128
Input 28
Safety/Emergency stop chain
E.201
Internal E-Stop „pushbutton“ tripped
E.211
External E-Stop 1 tripped
E.212
External E-Stop 2 tripped
Safety edge, general
E.360
Activation of internal safety edge
E.363
Fault in internal safety edge
E.370
Activation of external safety edge
E.373
Fault in external safety edge
E.379
External safety edge activated but not yet plugged in
RC plug-in module
E.401
RC Channel 1
E.402
RC Channel 2
Induction loop processor plug-in module
E.501
Detector Channel 1
E.502
Detector Channel 2
Internal inputs
E.900
Controller chip fault signal