Feig Electronic OBID ID RWA02.ABCD Series, Инструкция по монтажу

Страница: 22 / 26

Identifikation System OBID

Page 22 of 26 FEIG ELECTRONIC GmbH
E N G L I S H
6. Operation:
6.1 Configuration with the OBID
®
MasterCard
After power on the ID RWA stay’s for 1 sec in „MasterCard-Mode“ at minimum. In this time the
ID RWA try’s to receive a OBID
®
MasterCard (see also: „LED und Beeper Anzeigen“).
To configure the ID RWA with OBID
®
MasterCard’s make the following steps
1. Reset the ID RWA. After this the „MasterCard-Mode“ is active for 1 sec at minimum.
The ID RWA changes to the normal work mode, if no OBID
®
MasterCard is received during
this time.
If a OBID
®
MasterCard was received by the ID RWA, it stay’s for 2 sec longer in „Master-
Card-Mode“.
While the „MasterCard-Mode“ is active the LED’s are flashing
«
red
Õ
off
Õ
green
Õ
off
¨
.
2. If a valid OBID
®
MasterCard is received by the ID RWA, it reads the parameter’s of this
OBID
®
MasterCard and store’s it in the EEPROM.
3. After reading and storing the OBID
®
MasterCard the green LED and the beeper are active
for 800 ms.
4. After this further OBID
®
MasterCard’s could be read and stored.