OBID
®
i-
scan
Installation
ID ISC.LR200
FEIG ELECTRONIC GmbH
Page 31 of 50
M00601-4de-ID-B.DOC
E N
G
L I S H
8. Safety Instructions / Warning - Read before start-up !
Please read before initialization!
•
The device has to be used only for the purpose designed by the manufacturer.
•
The operation manual has to be stored available at any time and has to be handed over to each
user.
•
Unauthorized changes and the use of spare parts and additional devices which have not been
sold or recommended by the manufacturer may cause fire, electric shocks or injuries. Such
measures will lead to exclusion of any liability by the manufacturer.
•
The liability-prescriptions of the manufacturer in the issue valid at the time of purchase are valid
for the device. The manufacturer is not legally responsible for incorrect, unsuitable manual or
automatical setting of parameters for a device or the incorrect application of a device.
•
Repairs can only be executed by the manufacturer.
•
Installation-, operation- and maintenance procedures should only be carried out by qualified
personnel.
•
When working with devices with leading parts, please observe the valid security prescriptions.
•
Before opening the device, the power supply must always be interrupted. Make sure that the
device is without voltage by measuring.
•
CAUTION! The fading of an operation control (LED) is no indicator for an interrupted power
supply or the device being without voltage!
•
Works at the device and its installation have to be executed according to the national legal
requirements and local prescriptions.
•
The user is responsible for the installation, application and connecting of the device according
to the technical standards of the installation country and other valid prescriptions. Dimensions of
wires and cables, safety regulations, earthing, separation, disconnection (disconnect device
with contact distance min. 3 mm) , insulation control and overcurrent protection (rated current
Europe 16 A, USA 15 A) have to be considered in particular.
•
The dissipator on the back of the casing may heat severely during operation.
•
For connecting auxiliary equipment multiconductor cable has to be used.
