OBID
®
i-
scan
Application-Note
ID ISC.ANT800/600
FEIG ELECTRONIC GmbH
Page 7 of 33
N11000-2e-ID-B.doc
1.2. Required components
The following are required to construct the gate:
•
Qty. 1 ID ISC.LR200-A (Reader)
•
Qty. 3 ID ISC.ANTPS-A (180-degree, two-way Power Splitter)
•
Qty. 4 ID ISC.ANT800/600-A (800 x 600 mm Loop Antenna)
•
Qty. 5 EMC- ferrite toroids, available from: Würth Elektronik GmbH & Co.KG, diameter da=28,
B.No.742 701 4.
The cables on the antennas ID ISC.ANT800/600 and on the Power Splitter ID ISC.ANTPS-A are
each 3.5 m (11.5 ft) long. This means the Readers should be installed near the antennas. For
longer distances between Reader and base antenna, the ID ISC.ANT.EC extender can be used to
lengthen the antenna cable to 7.20 m (23.5 ft). This will however result in a slight loss of perform-
ance.
The cable extender also requires
•
2 x ID ISC.ANT.EC
Components required for commissioning:
•
Qty. 1 ID ISC.SATC-A Automatic Tuning Controller
•
Service software ISCStart Version 4.00 or higher on a PC running under MS Windows. The
ISCStart software is contained on the OBID® i
-scan
CD-ROM available from FEIG
ELECTRONIC GmbH.
•
Qty. 1 SWR Meter with SMA sockets or adapter to SMA sockets
•
Qty. 1 cable RG 58 C/U approx. 20 – 25 cm long with 2 SMA plugs
•
Qty. 1 amber blade screwdriver (Tuning tool for tuning capacitors)
•
Qty. 1 50
Ω
termination resistor with SMA male connector
For additional information on these devices, see individual instructions or section
