ORIGINAL INSTRUCTIONS
5
During maintenance and storage
Stop the tool and wait until it stops. Make sure all moving parts have come to a standstill.
Allow the machine to cool before performing inspection, adjustments, maintenance, servicing and storage.
Store the tool where fuel vapor will not reach a flame or spark.
When transporting and storing, always place the tool in its transport guard and protective device on it.
Causes of rebounds and prevention by the operator
Bounce may occur when the spout or end of the chain guide touches an object, or when the wood tightens and
pinches the cutting chain in the cutting section.
The contact of the tip may in some cases cause a sudden reverse reaction by bouncing the chain guide up and
back towards the operator.
Pinching of the cutting chain on the upper part of the chain guide can force the chain guide to the operator
abruptly.
Either of these reactions can result in loss of control of the saw likely to result in a serious personal injury. Do not
rely exclusively on safety devices built into your saw. As a chain saw user, all measures should be taken to
eliminate the risk of accident or injury during cutting.
Bounce results from improper use of the tool and / or incorrect operating procedures or conditions and can be
avoided by taking the appropriate precautions specified below:
-
Hold the saw with both hands firmly with the thumbs and fingers encircling the handles of the saw and place
your body and arms to allow you to withstand the rebound forces. The rebound forces can be controlled by
the operator, if appropriate precautions are taken. Do not allow the chain saw to start.
-
Do not stretch the arm too far and do not cut above the shoulder height. This helps prevent unintentional end
contacts and allows better control of the chain saw in unforeseen situations.
-
Use only the manufacturers specified replacement guides and chains. Incorrect replacement guides and
chains may cause chain breakage and / or rebound.
-
Follow manufacturer's instructions for sharpening and servicing the chain saw. A decrease in the depth gauge
level can lead to an increase in rebounds.
Residual risks
Even if you use this product in accordance with all safety requirements, the potential risks of injury and damage
remain. The following dangers can occur:
-
There are adverse health consequences resulting from the emission of vibrations if the tool is used for long
periods of time or is not properly managed and properly maintained.
-
The vibrations can produce the so-
called “white finger” disease. If any of the symptoms of "white finger" syndrome
appear, seek medical attention immediately. Symptoms of “white finger” include: numbness, loss of sensitivity,
tickling, tingling, pain, loss of strength, changes in color or skin condition. These symptoms usually appear on the
fingers, hands, or wrists. The risk increases at low temperatures. In order to reduce this risk, please wear gloves
and keep your hands warm. Limit the operating time.
-
There is a risk of hearing loss with prolonged use, especially if hearing protection is not worn. Always wear
hearing protection and limit the operating time.
