Assembly
The major components of this chipper/shredder have been assembled at the factory.
Some minor assembly is required. The assembly process will use all the parts and
hardware listed in the inventory.
DO NOT attempt to start this machine until all assembly has been completed. Serious
personal injury and damage to the machine could occur.
To assemble the chipper/shredder:
1. Tip the chipper/shredder over and remove the bolts shown in
Pic.2
. DO NOT turn the
chipper/shredder over once it is full of oil and gas. The oil and gas will spill out.
For fixing the leg: 3pcs Bolt M8x20, 1pc Bolt M8x200, 1pc Support Tube, 3pcs
Washer Ø8, 3pcs Locknut M8.
For fixing the wheel assembly: 2pcs Bolt M8x200, 2pcs Support Tube, 2pcs Washer
Ø8, 2pcs Locknut M8.
Pic.2
Attaching the leg
2. Attach the wheel assembly and the leg with the bolts that were removed in
Step 1
.
3. Place the handle on the hopper and line up all of the holes. Secure it with flat
washer(Ø8, 4pcs), spring washer(Ø8, 4pcs) and bolt(M8x20, 4pcs). (See
Pic.3
)
Pic.3
Installing the handle
4. Place the funnel over the studs in the side of the chipper/shredder and secure it with
flat washer(Ø8, 3pcs), spring washer(Ø8, 3pcs) and locknut(M8, 3pcs). (See
Pic.4
)
