ORIGINAL INSTRUCTIONS
14
b. Stopping the engine
Allow the chainsaw to run for a few minutes. Then turn the switch to the OFF position.
1. Main settings
a. Adjusting the carburetor
The carburetor is preset at the factory. To avoid malfunction, it is recommended not to adjust the adjustment
screws. If these screws require readjustment, have the machine serviced by your service center.
b. Chain brake
The chain brake is a device that automatically stops the chain in case a backward movement occurs, causing
the saw to jump. Normally, the brake is automatically activated by the inertia force.
It is also manually tightened by pushing the brake lever down and forward.
When the brake is running, a yellow sign comes out from the base of the brake lever.
To release the brake, pull the brake lever up until it clicks into place.
When the brake is working, release the throttle lever to slow down the engine speed. Continuous use when
the brake is running causes the clutch to heat up and can cause problems.
When checking the machine before using it, check the operating condition of the brake by performing the
following operations:
Start the engine and grasp the handle firmly with both hands.
While pulling the throttle control lever to keep the chain in operation, push the brake lever down with the
back of the left hand.
When the brake is running and the chain is stopped, remove the hand from the throttle.
Loosen the brake.
c. Release of the chain brake
To use the chain saw again, the chain brake must be released. This must be done machine off and cooled.
Pull the shield until it returns to its original position.
