ORIGINAL INSTRUCTIONS
17
6. MAINTENANCE AND STORAGE
1. Maintenance
Before any maintenance work, the machine must be switched off and completely cooled.
Perform the maintenance work according to the instructions below and perform them regularly. A clean,
well-maintained machine increases its standard of living and efficiency. On the contrary, a machine
maintained can cause damage, accidents and render the tool inoperable in the short term.
Any other maintenance, modification or repair work must be carried out by a qualified professional.
Do not immerse the tool in water or any other liquid.
a. After each use
-
Clean the engine block louvers with a blower.
-
Check the chain brake if it is working properly.
-
Clean the plastic parts before wiping with a damp cloth.
-
Check the use of the chain guide
-
Check the auto lubrication circuit if it is obstructed or not.
-
Check sprocket condition
-
Clean the cylinder fins with a compressor
b. Cleaning the air filter
Use a compressor to blow dust and chips.
To clean the filter foam: open the air filter, remove the foam. Clean this foam with gasoline, wring out and dry.
Replace the foam in the air filter and reassemble as described in the diagram.
After 10 uses, replace the foam with a new one.
c. Cleaning the oil filter and fuel filter
Clean these items regularly. Remove them from the tanks using clamps. Clean them with gasoline and then
put them back in place afterwards
d. Guide bar
Cleaning:
Remove
bar
guide
to
remove
dirt
from
grooves
and
oil
inlet.
Regularly grease the pinion.
Check: Reverse the bar from time to time to avoid the effects of wear. The bar rail should always be in place.
Use a ruler to observe it. If a gap is observed between them, then the rail is normal. Otherwise, the rail is worn
out. A bar must be corrected or replaced.
