Feider Machines FSO20254, Инструкция по эксплуатации

Страница: 7 / 26

ORIGINAL INSTRUCTIONS
7
Always check if the saw blade guard is working properly. It shall be well assembled, and it shall be
easily moving with hand and that it can be locked when operating the tool (see in instructions for
use).
Residual risks
Warning: When using a power tool, basic safety precautions should be taken to avoid the risk of fire,
electric shock or injury to persons.
Please read the additional safety instructions in this manual carefully and note that even if the
power tool is used in accordance with the operating instructions, it is not entirely certain that all
residual risk factors will be eliminated. The following hazards can occur:
o
Contact with blade
o Rebound of the workpiece or debris of the workpiece
- Fracture of the blade.
- Ejection of debris from the machined part.
- Hearing damage if you do not wear ear plugs.
- Projection of wood chips that are harmful to health when the tool is used in a poorly sealedroom.
It is therefore important to take preventive measures:
o Always use a sawdust disposal device if possible.
o Do not use deformed or cracked blades.
o Remove the plug from the power tool before any adjustment or maintenance, including
replacement of the blades.
o
Choose a suitable blade for the material to be cut.
o Do not use the saw to cut material other than those designated by the manufacturer
The miter saw can be transported safely by the main handle, but only when it has been
disconnected from the power outlet and locked in the locked position.
Do not use the saw when the guards are not properly assembled, in good condition or properly
maintained.
Make sure that the arm is securely secured during bevel cutting.
Apply the workpiece strongly against the swivel table on which there should be no other pieces of
wood.
Install sufficient lighting.
Make sure you have been trained or trained and know how to adjust and use this tool.
Use blades that are properly sharpened and do not exceed the maximum rated speed.
Do not pick up debris from the cutting area until the blade guard closes and the saw comes to a
complete stop.
Attach the miter saw to a workbench if possible.
When cutting a long piece that extends far beyond the width of the table, supports must be used to
support the ends of the workpiece at the same height as the cutting table.
The supports must be positioned so that the workpiece does not fall to the ground when the cutting
has finished. If the part is very long, several supports must be provided.

keep the floor area free of loose material e.g. chips and cut-offs;

ensure that any spacers and spindle rings used are suitable for the purpose as stated by the
manufacturer