3.
The engine stops
Electronic card blocked due to:
Turn the key to pos. «OFF» and look for
the
cause of the problem:
–earth connections of the micros witches
–check connections
disconnected
–flat battery
–recharge battery (
☛
6.2.3)
–badly connected battery (poor contact)
–check connections (
☛
3.5)
–engine badly earthed
–check engine earth connection
4.
The engine does not start
– earth connections of the micros witches
–check connections
disconnected
– you are not ready for starting
–check that the conditions
allowing the start are
met
(
☛
5.2.a)
5.
The engine stops
–earth connections of the micro switches
–check connections
Disconnected
6.
Starting is difficult or the
–fault in carburetion
–clean or replace the air filter
engine runs erratically
–flush out the float chamber
–empty fuel tank and refill with fresh fuel
–check and, if necessary, replace fuel filter
7
.
Weak engine performance
–forward speed too high in relation to
–reduce the forward speed and/or
raise
during cutting
cutting height
the cutting deck
(
☛
5.4.5)
8
.
Engine stops when blade is engaged
–you are not ready to engage the blade
–check that the safety
requirements are
met(5.2.b)
9
.
Unusual vibrations while working
–blade unbalanced
–Contact your dealer
–blade loose
–Contact your dealer
–fixing bolts loose
–check and tighten all the fixing bolts
of the engine and frame
10
.
Uncertain or ineffective braking
–the brake is not adjusted correctly
–Contact your Dealer
11
.
Uncertain or ineffective braking
–the brake is not adjusted correctly
–Contact your Dealer
32
