Recharging must be done using a battery charger at
constant voltage
. Other recharging systems can irreversibly damage the battery.
The machine comes with a connector (1) for recharging, near the battery, to be connected
to the connector for the battery-charger supplied (if included) or available on request (
☛
9.2).
This connector must only be used for connecting to the
battery charger. For its use:
6.3 INTERVENTIONS ON THE MACHINE
6.3.1 Cutting deck alignment
The cutting deck should be properly set to obtain a good cut.
If the cut is uneven, check the tire pressure.
If this is not sufficient to achieve an even cut,
please contact your Dealer for the adjustment
of the alignment of the cutting deck.
6.3.2 Replacing wheels
1. Place the machine on a flat surface and put blocks
under a load-bearing part of the frame on the side of the
wheel to be changed;
2. using a screwdriver, remove the snap ring
(1)
and the
washer
(2)
;
3. pull out the wheel
Smear some waterproof
grease on the axle and after refitting the wheel; carefully refit the washer (2) and the
snap ring (1).
If you have to replace one or both rear wheels, make sure
that any differences in their external diameter does not exceed 8-10 mm; on the contrary,
to prevent an uneven cut it will be necessary to adjust the alignment of the cutting deck.
1
2
29
