Feider Machines Fm20V115, Инструкция по эксплуатации

Страница: 13 / 24

８
a. Charging
1). Take the battery pack out of the equipment. Do this by pressing the side pushlock buttons.
2). Check that your mains voltage is the same as that marked on the rating plate of the battery
charger. Insert the power plug of the charger into the socket outlet. The RED LED will then
begin to light.
3). Insert the battery pack into the battery charger .then the red LED on charger will begin to
Green flash light.
4). You will find a label
with “Charger indicator” of the LED indicator on the charger.
The battery pack can become a little warm during the charging. This is normal.
If the battery pack fails to charge, check:
⚫
Voltage at the power socket
⚫
Whether there is good contact at the charging contacts.
⚫
Whether the battery pack is warm or not, The battery protection system will not allow the
battery to be charged if the battery temperature is over 40
℃
after use, allow the battery
pack to cool to room temperature before commencing with the charging.
If the battery pack still fails to charge, send the charging unit and the battery pack to our
customer service center.
To ensure that the battery pack provides long service, you should take care to recharge it
promptly. You must recharge the battery pack when you notice that the power of the cordless
vacuum drops. Never allow the battery pack to become fully discharged. This will cause it to
develop a defect.
Battery capacity indicator
Press the switch for the battery capacity indicator . The battery capacity indicator shows the
charge status of the battery using 4 LEDs as following: