ORIGINAL INSTRUCTIONS
Fill the boiler with at least 500ml of water. In order to get dry steam, fill the boiler to the maximum
(2000 ml). Overfill water will bring water in the steam.
NOTE:
Only use clean water
Note: we recommend using gloves to protect you from any scald.
4: Be sure that the boiler has been filled and that all desired accessories are connected before
following steps.
5: Plug the power cord into an electrical outlet.
6: Turn the power on. The power on/off will immediately illuminate, indicating that the boiler is
heating.
7: The water in the boiler will be ready for steam cleaning within 8 to 10 minutes (depending on how
much water is in the boiler).
8: If green light show at the first time, means steam is ready. Point the any accessory towards the
surface your desire to steam.
Hold on the steam gun by hand and move the steam button ahead. Steam will come out directly.
If you need automatic steam without hand, just turn the steam lock to the right side when in using.
There will be some water first. Do not use to clean carpet, ironing cloth etc. Spray to some
container. It will be normal in 2-3 seconds.
You can adjust the steam amount with the steam knob situated on the gun, accordingly to actually
situation.
For a long time of using, push the button and you turn the steam lock to the right side
; the
steam will come out automatically for a continuous time. To stop, turn the steam lock to the left side.
Note:
Temperature can reach 108 degrees
