6. MAINTENANCE
Replacing hydraulic oil (fig.12)
Replace the hydraulic oil in the log splitter after every 150 hours of use. Take following steps to
replace it.
1. Make sure all moving parts stops and the log splitter is unplugged.
2. Unscrew oil drain bolt
(14 ) (fig.6)
with dipstick to remove it.
3. Turn the log splitter on the support leg side over a 2.4 liters capacity container to drain the
hydraulic oil off.
4. Turn the log splitter on the motor side.
5. Refill fresh hydraulic oil at the volume as per the hydraulic oil capacity of a particular model
indicated in the specifications table.
6. Clean the surface of Dipstick on the oil drain bolt and put it back into the oil tank while keep the
log splitter vertically.
7. Make sure the level of the refilled oil is just between 2 grooves around the dipstick.
8. Clean the oil drain bolt before thread them back. Make sure they are tightened to avoid leakage
before placing the log splitter horizontally.
fig.12
Periodically check oil level to ensure it is between 2 grooves around the dipstick. Upon
lower oil level, oil refilling is required.
Warning: Never mix oil with general waste!
Used oil must be disposed of according to current regulations in the country where the
machine is used.
Sharpening the wedge
After using the log splitter for some time, sharpen the wedge of the log splitter using a fine-toothed
file and smooth any burrs or crushed area along the cutting edge
7. STORAGE
When you have finish working with your log splitter:
1. Disconnect the log splitter from the mains supply.
2. Tighten the oil yank cover / air bleeder,
3. Clean the unit down using a dry cloth.
4. Store in a dry and well-ventilated area.
15
