NOTE: If you choose a machine without extra legs, please place the machine safely on the
workbench surface 850mm above the ground before using.
5. OPERATION
Warning!
Before operating the log splitter, the Bleed Screw (15) Fig. 6, should be loosened by some
rotations until air can go in and out of the oil tank smoothly.
Air flow through the Bleed Screw hole should be detectable while the log splitter is under
operations.
Before moving the log splitter, make sure the Bleed Screw is tightened to avoid oil leaking
from this point.
Failed to loosen the bleed screw will keep the sealed air in hydraulic system being compressed
after being decompressed, such continuous air compression and decompression will blow out the
seals of the hydraulic system and cause permanent damage to the log splitter.
Fig.6
DO NOT ADJUST THE MAX PRESSURE
LIMITING SCREW (16) IN FIG. 7!
Max pressure was set before the log splitter ex work and the max pressure limiting screw is
tightened to ensure the log splitter works under pressure no more than 6 tons. The setting
was done by qualified mechanic with professional instruments.
Unauthorized resetting will cause the hydraulic pump fail to output enough splitting
pressure or RESULT IN SERIOUS INJURY AS WELL AS DAMAGE TO THE MACHINE.
Fig. 7
12
