Feellife Air Flow 1, Инструкция по эксплуатации

Страница: 10 / 73

Do not swallow or spit during rinsing.
10
5. Choose a desired mode: By pressing the buttons ”+” & ”-” to set
the desired rinsing rate. We recommend that you start with the
lowest rate. The device would enter the “Low speed spray rate"
mode when activated. Short press the “+” button to switch the
rinsing mode in the order of “High speed spray rate”” Frequency
pulse spray rate”. When setting to the corresponding mode, the
green indicator light under the buttons will on.
Low speed means that the flow rate has less impact than other
modes, which is suitable for the elderly and children, as well as
those with damaged nasal mucosa, and is gentler; high speed
means regular flushing, which is used according to personal
acceptance.
Frequency pulse is a short pulse wave generated according to
current and voltage signals, and water flow is also in the form of a
pulse wave. The pulse form is more conducive to nasal cavity
cleaning and cleaning, and it can be used by people of all ages.
6. The wasted water will flow back to the Wash Water Tank (the
side without Tubing). After rinsing, you should pour out the wasted
water. Usually, clean one nasal cavity needs 10ml-25ml wash water.
You can adjust it according to your own situation and doctor's
advice. Rinse the other side of the nasal cavity as above. After
rinsing, press Power Switch to power off. Pour out the residual liquid
from the Water Storage Tank. (Shown as the figure below.)