Feel-Maestro MR318C, Руководство пользователя

Страница: 6 / 40

6
STEAM IRONING
- Filling the reservoir
Please note! Do not use chemical additive, scented substances or decalcifiers.
- Check that the plug is disconnected from the socket.
- Move the steam selector to “0”.
- Open the lid (11/Picture 1)
- Raise the tip of the iron to help the water enter the opening without overflowing.
- Slowly pour the water into the water tank Picture 2.2 using the special measure and
taking care not to go over the maximum level indicated by “MAX” on the reservoir
- Close the lid
- Make sure that the AC voltage selector (7/Fig. 1) on the device is set to the position
corresponding to the used electrical network (110-220 V, 50 Hz).
SELECTING THE TEMPERATURE
- Put the iron in a vertical position.
- Put the plug in the socket.
- Adjust the thermostat knob (9/Picture 1) according to the international symbol on the
garment label [Table1]. The plate temperature control light (7/Picture 1) indicates that the
iron is heating up. Wait until the plate temperature control light goes off before ironing.
Please note: the iron gives off steam continuously only if you hold the iron horizontally.
You can stop the continuous steam by placing the iron in a vertical position or by moving
the steam selector to «0». As indicated on the thermostat knob and in the initial table, you
can only use steam at the highest temperatures. If the selected temperature is too low,
water may drip onto the plate.
DRY IRONING
To iron without steam, follow the instructions in section “steam ironing”, leaving the steam
selector (8/Picture 1) in the position ”no steam”.
SELF-CLEANING
The self-cleaning feature cleans inside the plate, removing impurities. We recommend
using it every 10-15 days. Directions:
-Fill the reservoir according to the “filling the water reservoir” section.
-Plug the product into a standard electrical outlet near a sink , turn the temperature control
dial the MAX position, rest the heel of the iron on a flat, stable surface and allow it to heat
until the temperature light (8/Picture 1) goes out.
- Set the steam regulator to the mark of the maximum steam supply.
- Boiling water and steam will be released from the soleplate do not use the, taking
impurities with them . Move the iron forward and backward until the water reservoir is
empty. Then, turn the steam control dial to ”no steam” and the temperature control dial to
MIN . Unplug the product, rest it on the heel . and allow it to completely cool.