Electrical Connection of AromaSteam
IMPORTANT NOTE:
AromaSteam is for use with AirTempo
®
iSteam
®
and iTempoPlus
®
con trols only.
1.
Disconnect all power to the MrSteam steam generator.
Failure to disconnect power may result in an electrocution hazard.
2.
Remove the top cover.
3.
Run the request cable from the AromaSteam through one of the knock outs in the side of the steam bath
generator. Use a strain relief bushing or grommet to prevent chafing.
4.
Locate the two quick connect tabs labeled “AROMA” on the printed circuit board in the location shown.
5.
Connect the request cable to the terminals. The terminals are not polarized.
6.
Connect AromaSteam’s transformer into a 120VAC/240VAC wall outlet.
I N S T A L L E R S E C T I O N
AromaSteam
Operation and Installation Instructions
®
AromaSteam Connections
Steam Generator
Circuit Board
AromaSteam Pump
AromaSteam Transformer
120VAC/240VAC
Typical MrSteam
Steam Generator
(shown with cover removed)
Request
Cable
AromaSteam Connections
Steam Generator
Circuit Board
12
All Drawings for Illustrative Purposes Only
Receptacle
Required
