Federal ITD Series, Инструкция по установке и эксплуатации

Страница: 53 / 64

- 53 -
6. Disconnect power to display case.
7. Remove the rear doors as described in rear door removal section
8. Remove all interior shelving as described in the shelving installation and removal section of this
manual.
9. Remove both shelf standards from interior of case by removing thumb screws located at top and
bottom of shelf standard.
10. Remove end glass as described in end panel removal section of this manual.
(Step 6 & 7 Refrigerated Models Only)
11. Lift the Display Deck(s) up and out of evaporator tub and remove from case.
12. Remove the evaporator fan shroud by removing the thumbscrews along the backside of
evaporator fan shroud and the (2) thumb screws on each side of evaporator coil. Unplug fan(s)
from wire harness and remove evaporator fan shroud with fan attached from case.
13. Clean the entire interior of the case using warm soapy water. Wipe off all soapy water with a
damp cloth and allow to dry.
14. Clean all shelves, shelf support bars, shelf standards, shelf brackets, and display deck using
warm soapy water and a brush. Rinse thoroughly and allow to dry.
15. Clean behind front glass hinge using warm soapy water and sweeping debris to each end and
16. Clean all foreign material from inner and outer rear door tracks using warm soapy water and a
brush. Apply a light film of lubricant such as PAM to make the doors operate smoother.
17. Clean both sides of the doors, end glass and front glass using any common window cleaner.
IMPORTANT: Do not allow glass cleaner to contact any of the Acrylic front deflector, front
lift-up doors, and plastic inner doors. The front glass can be tilted forward to allow easier access
to clean interior. Tilt the front glass out by grabbing the top edge of glass with finger tips and
pulling it away from magnetic strips on case. Tilt glass until it stops at about 30 degrees angle.
IMPORTANT: Hold on to the glass until it stops and do not let it free fall or damage to glass or
hinge may occur. Close the glass by pushing glass back up against magnetic gasket in closed
position.
18. IMPORTANT: Cleaning the Acrylic plastic front deflector, front lift-up doors, and plastic inner
doors require special care to prevent hazing and yellowing of material. Lightly dust (not wipe)
surface with clean soft cloth. Then the surface can be wiped carefully with a soft, wet cloth or
chamois. The cloth or chamois must be kept free of grit by frequently rinsing in clean water.
Grease and oil can be removed with kerosene. Do not use window cleaners or kitchen scouring
compounds. DO NOT use solvents such as Acetone, Benzene, Carbon Tetrachloride, and
Lacquer Thinners. A spray wax such as Pledge or Maguire’s polish can be applied and wiped
with a clean soft cloth. The wax tends to fill in and hide small scratches.
19. Reassemble the case in reverse order.