Federal FCCR-4, Инструкция по установке и эксплуатации

Страница: 7 / 27

7
Shelving
The case is equipped with three tiers of adjustable glass shelves. The deepest shelf is at the bottom
and the shallowest at the top. Each tier is supported by three (3) shelf brackets.
Turn the shelf light switch “off”.
Remove both rear doors from the track by lifting them upward until the bottom edge clears the lower
door track and then outward.
To install the bottom shelf, put a 14” shelf bracket in the end shelf standard even with or above the
bottom light socket and tighten the locking cam.
Then install a center shelf bracket in the center shelf standard and tighten the locking cam. The
center shelf bracket has no end hook and is shorter than the end brackets in order to clear the shelf
light housing.
Before 11/01/21 Hang the shelf light assembly with the longest cord on the end shelf brackets.
Plug the shelf light cord in the light sockets. Make certain the light cord is completely inserted into
the socket or arcing may result causing damage to the plug and socket.
After 11/01/21 hang shelf support w/light attached on shelf brackets as shown & insert shelf light
plug into end of shelf light.
Each shelf bracket gets two plastic supports with rubber pads. Put two single width supports on each
end shelf bracket. Put two double width supports on the center shelf brackets.
Repeat the steps for the middle and top shelves.
Put the glass shelves on the support pads as shown for each tier. If the shelf is not in the proper
position, it may disrupt the air flow in the case and cause product loss.
Reinstall both rear doors.
BEFORE 11/01/21
AFTER 11/01/21
Lights
Make certain that the light cord plugs are completely inserted into the sockets or arcing may result
causing damage to the plugs and sockets.
Cleaning
For initial setup, clean the case as outlined in the weekly cleaning section.