Vision
®
SLR with Standalone SignalMaster
®
Supplement
2
Vision SLR with Standalone SignalMaster
Federal Signal
www.fedsig.com
Introduction
This publication provides supplemental instructions for installing the Vision SLR light bar with Standalone
SignalMaster to a vehicle.
Unpacking the Kit
After unpacking the kit, inspect it for damage that may have occurred in transit. If it has been damaged,
file a claim immediately with the carrier stating the extent of the damage. Carefully check all envelopes,
shipping labels, and tags before removing or destroying them. Ensure that the parts shown in Table 1 are
contained in the packing carton. If you are missing any parts, contact Customer Support at
1-800-264-3578, 7 a.m. to 5 p.m., Monday through Friday (CT). An installer-supplied control head for
controlling the functions of the light bar is also required.
Table 1 Kit contents
Qty.
Description
Part No.
1
Eight-Position Female Connector
140325-06
1
Eight-Position Male Connector
140333-08
2
Mounting Bracket
8652180
4
#10 Type B Pan Head Torx
®
Black Stainless Steel Screw 7011246-06
2
1/4-20 Stainless Steel Keps
®
Nuts
7058050
Mounting the SignalMaster
LOCATING OPERATOR CONTROLS: Locate the light system controls so the vehicle and
controls can be operated safely under all driving conditions. Failure to heed this warning could
result in driver distraction or driver error while operating the vehicle.
ROOF SUPPORT STRUCTURE: There is a roof support member that spans the distance between
the driver and passenger side. DO NOT DRILL THROUGH THIS MEMBER! Adjust any hole
locations until the holes can be drilled without going through this member. Failure to follow this
warning will weaken the roof of the vehicle and may lead to an increased chance of bodily injury
or death in a rollover accident.
SIGNALMASTER ORIENTATION: The SignalMaster light bar must be oriented correctly for
proper operation. The assembly should be installed with the ROC board on top.
IMPORTANT
: Plan all cable routing before completing the installation. Plan the location of the wire
routing hole so that the cable does not have tight bends.
To mount the SignalMaster:
1.
Determine the desired distance between the mounting holes and attach the mounting brackets to
the SignalMaster with the #10 Torx screws.
2.
Mark the positions of the two mounting holes and the hole for the cable.
3.
Drill two mounting holes 0.257 inch to 0.265 inch in diameter and a hole 0.375 inch in diameter for
the cable.
