Valor
®
Low-Profile Hook Mount Manual
6
Valor Low-Profile Hook Mount Kit
Federal Signal
www.fedsig.com
Figure 4 Mounting foot inboard of gutter
RH Mounting Foot
Torx
®
Screw
Hook Attach Bracket
and Mounting Pad
Figure 5 LH mounting foot side view
LH Mounting Foot
Hook Adjust
Bracket
Valor
3.
Center the light bar assembly so that the end of the assembly and edge of the roof are equidistant
on each side of the vehicle. Ensure that the gutter hooks, when installed, will not interfere with the
door or door glass. Improper clamping on the vehicle roof may result if the gutter hooks contact the
mounting feet. If needed, adjust the mounting feet before tightening the 5/16-inch hex nuts.
4.
Remove the light bar assembly from the vehicle roof and place it on soft rags or cardboard to avoid
marring the plastic domes.
5.
Turn the light bar assembly over so that the bottom of the assembly faces up.
6.
Tighten to 10-15 ft-lb the eight 5/16-inch nuts (four on each mounting foot) installed in Step 2 under
"Installing the Adjustable Foot Brackets" on page 4.
Hook Mounting the Valor on the Vehicle
To mount the light bar on the vehicle:
1.
Place the light bar assembly back into its original position on the vehicle roof.
2.
Move the adjuster brackets to the desired height while keeping the light bar level slightly nose down
(1/8 inch). To prevent roof damage, make sure that there is no contact with the roof.
