Installation and Programming Instructions
9
SignalMaster
™
Model 330104 SMC1 Light Bar Controller
Federal Signal
www.fedsig.com
Safety Message to Operators of Warning Light Equipment
Peoples’ lives depend on your safe use of our products. Listed below are some important safety
instructions and precautions you should follow:
• Do not attempt to activate or de-activate the light system control while driving in a hazardous
situation.
• Although your warning system is operating properly, it may not be completely effective. People may
not see or heed your warning signal. You must recognize this fact and continue driving cautiously.
• Also, situations may occur which obstruct your warning signal when natural or manmade objects are
between your vehicle and others, such as: raising your hood or trunk lid. If these situations occur, be
especially careful.
• This product controls high intensity LED devices. To prevent eye damage, DO NOT stare into the light
beam at close range.
• At the start of your shift you should ensure that the light is securely attached and all lamps are
operating properly. The LED display on the control only simulates the operation of the lamps.
• If a selected function does not perform properly or if any of the lamps remain illuminated when the
control is off, disconnect the power connector from the controller and contact the nearest service
center.Failure to follow these safety precautions may result in property damage, serious injury, or
death.
Operating the SignalMaster Controller
All controls for the SignalMaster directional lights are located on the front panel of the controller. The
LED display simulates the active light pattern. See Figure 3 on page 7.
Function Activation
The Model 330104 controller gives the function of the latest priority. If the RIGHT directional signal is
active when the WARN button is depressed, the controller produces the warn pattern. It will then turn
off the warn pattern if the WARN button is pressed a second time. If another button is pressed, then the
function controlled by the newly pressed button becomes active. To turn off the function, the button must
be pressed a second time.
LEFT ARROW Button
Displays a left-arrow flash pattern that instructs traffic to move left. The pattern is more fluid in Title 13
Mode.
CENTER OUT Button
Displays a center-out flash pattern that instructs traffic to move around either side of the vehicle.
RIGHT ARROW Button
Displays a right-arrow flash pattern that instructs traffic to move right.
WARN Button
Displays a non-directional warning pattern. See Table 5 on page 7 and Table 6 on page 8 for available
patterns.
