background image

Installation and Programming Instructions

10

SignalMaster

 Model 330104 SMC1 Light Bar Controller 

Federal Signal 

www.fedsig.com

Testing the Installation

LIGHT HAZARD: To be an effective warning device, an emergency warning system produces 

bright light that can be hazardous to your eyesight when viewed at a close range. Do not stare 

directly into the lights at a close range, or permanent damage to your eyesight may occur.

After testing the installation, test the emergency warning system to ensure that it is operating properly. 

Also test all vehicle functions, including horn operation, vehicle safety functions, and vehicle lighting 

systems to ensure proper operation. Ensure that the installation has not affected the vehicle operation or 

changed any vehicle safety functions or circuits. 
Do not test the vehicle’s light system while driving. Operating the vehicle warning systems may pose 

a hazard to the operator and other drivers if the systems do not function as expected. Test the vehicle 

only in a controlled environment. After testing is complete, provide a copy of these instructions to the 

instructional staff and all operating personnel. 

Getting Technical Support

For technical support, please contact:
Federal Signal Corporation  

Service Department 

Phone: 1-800-433-9132 

Email: [email protected]

Getting Repair Service

The Federal Signal factory provides technical assistance with any problems that cannot be handled 

locally. Any product returned to Federal Signal for service, inspection, or repair must be accompanied 

by a Return Material Authorization (RMA). Obtain a RMA from a local Distributor or Manufacturer’s 

Representative. Provide a brief explanation of the service requested, or the nature of the malfunction. 
Address all communications and shipments to the following: 

Federal Signal Corporation  

Service Department  

2645 Federal Signal Dr.  

University Park, IL 60484-3167

Limited Warranty

 

This product is subject to and covered by a limited warranty, a copy of which can be found at  

www.fedsig.com/SSG-Warranty. A copy of this limited warranty can also be obtained by written request 

to Federal Signal Corporation, 2645 Federal Signal Drive, University Park, IL 60484, email to info@fedsig.

com or call +1 708-534-3400. 
This limited warranty is in lieu of all other warranties, express or implied, contractual or statutory, 

including, but not limited to the warranty of merchantability, warranty of fitness for a particular purpose 

and any warranty against failure of its essential purpose. 

Содержание SignalMaster 330104 SMC1













Отзывы: