Mounting the Pathfinder
25
Installation and Maintenance Instructions
Federal Signal
www.fedsig.com
Figure 6 Bail Bracket Assembly
Mounting the Siren
To mount the siren:
1.
Use the bracket as a template or use the dimensions shown in Figure 5 to mark
the centers of the two mounting holes.
2.
Choose a bit appropriate for the installer-supplied mounting hardware and drill
the center of the two mounting holes.
3.
Mount the bracket with the installer-supplied mounting hardware.
4.
Insert the 1/4-20 carriage bolts into the bracket and loosely install the 1/4-inch
washers and Keps nuts.
5.
Slide the siren onto the bracket assembly and tighten the 1/4-inch nuts. Do not
overtighten.
Mounting the Control Head (PF 100R and PF200R)
The control head comes with two mounting brackets and mounting hardware.
To mount the control head:
1.
Secure a bracket to the control head with the 6-32 by 1/4-inch Phillips screws
and #6 lock washers (Figure 7 on page 25).
2.
Using a 7/16-inch nut driver, secure the other bracket to the control head/
bracket assembly with the 1/4-20 by 3/4-inch hex head screws and 1/4-inch lock
washers (Figure 8).
3.
Use the mounting bracket as a template and scribe two drill position marks at
the selected mounting location.
