12
Installation
Informer-IP Wall Mount Series B (Model I-IPW)
Recessed Mounting
Before putting the Informer-IP in place, determine a suitable location considering the
criteria listed in this manual. The Informer-IP has four holes for recessed mounting, two
sets of two, located on the sides of the unit which accept #10 screws. Mounting location
determines which set of holes are used or both. Exterior wiring can enter the Informer-IP
through any of the unit’s knockouts: located on the back, bottom, and each side of the
unit. Place the mounting screws horizontally level. Ensure the screws are placed into
material that can adequately support the weight of the Informer-IP.
Figure 4 Side View - Hole Measurements
To recess mount, do the following:
1. Cut a hole that is 8.25 x 7.25 x 3 inches (H x W x D), which is slightly larger than the
Informer-IP base and next to a wall stud.
2. Attach the face bracket to the sides of the unit using the four 10-32 screws included.
3. Slide the Informer-IP into the wall and from the inside of the unit mark the side hole
locations on the wall stud.
4. Remove the unit and drill the two holes for #10 screws.
5. Place the mounting screws horizontally level.
NOTE
: Ensure the screws are placed into material that can adequately support the weight
of the Informer-IP and that the screws are tightened sufficiently to securely fasten the unit
to the stud.
