9. Before replacing dome, ensure that the gasket is properly seated on the die-cast base. Place
the dome over the base, aligning the recesses inside the dome lip with the four pins on the
base. Push down on the dome and turn clockwise until it locks in place (approximately 3/4-
inch).
10.
Replace the screw in the bottom of the dome.
11.
Reassemble the light and test for proper operation.
C. Service.
The Federal factory will service your equipment or provide technical assistance with any
problems that cannot be handled locally.
Any units returned to Federal Signal for service, inspection, or repair must be accompanied by
a Return Material Authorization. This R.M.A. can be obtained from the local Distributor or
Manufacturer’s Representative.
At this time a brief explanation of the service requested, or the nature of the malfunction,
should be provided.
Address all communications and shipments to:
FEDERAL SIGNAL CORPORATION
Electrical Products Division
Service Department
2645 Federal Signal Drive
University Park, IL 60466-3195
D. Replacement Parts.
Description
Part Number
Dome, Amber, Kit
K8550320A
Dome, Blue, Kit
K8550320A-01
Dome, Clear, Kit
K8550320A-02
Dome, Green, Kit
K8550320A-03
Dome, Red, Kit
K8550320A-04
Dome, Magenta, Kit
K8550320A-05
Flash Tube/Trigger Coil Assy.
K8107177A
Fuse, 120 and 230-240 VAC units,
K148A155A-01
1A, 250V
Circuit Board, 12-24VDC
K2001202C
Circuit Board, 120VAC
K200D866G
Circuit Board, 230-240VAC
K200D866G-01
Circuit Board, Inrush Current, 24VDC
K2001918A
-4-
Содержание FB2PST
Страница 2: ......
Страница 19: ......
Страница 20: ...256896P REV P Printed 9 04 Printed in U S A ...