Federal Signal Corporation e-Q2B, Инструкция по установке, обслуживанию и ремонту

Страница: 22 / 60

Chapter 3: Wiring the e-Q2B Siren System
e-Q2B Siren System
22
Figure 3.6 e-Q2B 200-watt speaker connections (BP200-Q or BP200-EF)
-POWER
-OUTPUT
-LOAD
LIMIT-
SHORT-
THERMAL-
SPEAKER OUTPUT
− BLK − GRN + WHT + RED
FOUR-POSITION
SPEAKER CONNECTOR
P/N 140417-04
FS SUPPLIED 20 FT
SPEAKER CABLE
AND CONNECTOR
CONNECTOR
POSITION
WIRE
COLOR
SPEAKER CONNECTION
1
2
3
4
BLACK
WHITE
GREEN
RED
FRONT DRIVER NEG. (–)
FRONT DRIVER POS. (+)
REAR DRIVER NEG. (–)
REAR DRIVER POS. (+)
FS SUPPLIED 20 FT SPEAKER
CABLE AND WEATHERPROOF
CONNECTOR AT SPEAKER
1
2
3
4
BP200-Q OR BP200-EF
200-WATT SPEAKER SYSTEM
RED WHT
GRN
BLK
1. LOOSEN SCREW.
2. INSERT STRIPPED
WIRE IN CONNECTOR.
3. TIGHTEN SCREW.
TO EXTEND LEADS, USE WIRE
THAT IS 18 AWG OR THICKER
INSULATION STRIPPED
0.25 in (0.635 mm)
290A6805
Connecting Two BP100 or ES100 Speakers to the e-Q2B-200
To connect the two 11-ohm, 100-watt speakers to the Model e-Q2B-200 siren amplifier:
1. Mount the e-Q2B Siren System components according to the instructions included with
each product.
2. Grommet holes through which the speakers wires will pass. Route the speaker wires
through the vehicle compartment to the amplifier.
3. Carefully strip 1/4 inch of insulation from the speaker wires.
4. Use 18 AWG or thicker wire to extend and connect the speaker leads.
5.
Terminate the conductors in the supplied connector that mates with the SPEAKER
OUTPUT terminal block of the amplifier as shown in Figure 3.7:
◆
The positive (+) wire from Speaker B is terminated in the +WHT position. The negative
( – ) wire from Speaker B is terminated in the –BLK position.