After the desired pattern has been selected
connect the programming wire (green) directly to the
positive power wire (red).
The unit is designed to return to the last flash
pattern selected before it was de-energized. For example,
if the unit is de-energized at the seventh flash pattern
and then re-energized, the seventh pattern illuminates.
However, there is a two second delay for the unit to
remember the last flash pattern. So, if the unit is energized
and functioning on the third flash pattern and the unit
is switched to the fourth flash pattern and de-energized
within two seconds, the unit will return to the third flash
pattern when the unit is re-energized.
B. External Flashing Device Operation.
1. High side activated flasher.
Use a user supplied 3A fuse and connect
the red and green wires to the output control lead on the
flasher. Connect the black, yellow, orange and white wires
to ground.
2. Low side activated flasher.
a. Dual flashing unit.
Using a user supplied 3A fuse, connect the
red and green wires to a switched 12V source to eliminate
standby current. Connect the orange wire to one of the
output leads of the flasher. Connect the white wire to the
Figure 2.
other output lead of the flasher. Connect the black and
yellow wires to ground.
b. Single flashing unit.
Use a user supplied 3A fuse and connect
the red and green wires to a 12V source. Connect the white,
orange, black, and yellow wires to the output control lead
on the flasher.
SAFETY MESSAGE TO OPERATORS
People’s lives depend on your safe use of our
products.
Listed below are some important safety in
-
structions and precautions you should follow:
• Although your warning system is operat
-
ing properly, it may not be completely ef
-
fective. People may not see or heed your
warning signal. You must recognize this
fact and continue driving cautiously.
• Also, situations may occur which obstruct
your warning signal when natural or
manmade objects are between your vehi-
cle and others, such as: raising your hood
or trunk lid. If these situations occur, be
especially careful.
• This product contains high intensity LED
devices. To prevent eye damage, DO NOT
stare into the light beam at close range.
• At the start of your shift, you should en
-
sure that the light is securely attached
and operating properly.
Failure to follow these safety precautions may
result in property damage, serious injury, or death to
you, to passengers, or to others.
RETAIN AND REFER TO THIS MESSAGE
-3-
290A5950
CUDATRIOPTIC
+12V
CONTROL LEAD
(12V SIGNAL ACTIVATED)
RELAY
FUSE
STROBE SUPPLY
