Figure 1.
-2-
2. See figure 1. Locate the opening in the selected
mounting bolt channel and drop in two #8-32 hex head
screws.
Before drilling in ANY part of the vehicle, be sure
that both sides of the mounting surface are clear of
parts that could be damaged; such as brake lines,
fuel lines, electrical wiring or other vital parts.
3. Drill two 3/16” hole as needed for the #8-32
mounting screws. It is recommended that the screws be 5-
8” apart.
4. Secure the unit to the mounting surface using the
supplied keps nuts.
Install the control unit in an adequately ventilated
area. Never install near heater ducts.
After prolonged operation, the unit dissipates heat
and can cause burns. Do not hold the unit in your
hands for extended periods of time. Do not touch
the unit during, or shortly after, operation. Always
allow the unit to cool before handling.
III. ELECTRICAL SPECIFICATIONS AND FEATURES.
NOTE
Powering multiple devices with a common con-
trol lead may cause one or more units to briefly
remain functional after signal power is removed.
For example, due to high input filter capacitance,
a strobe supply can briefly supply the current
required to operate a low current device such as a
Cuda TriOptic. If necessary, use a relay to isolate
devices with large filter capacitors. See figure 2 for
suggested schematic, all components and wires are
user-supplied.
A. Flashing Operation.
1. Cut and insulate the orange, yellow and white
wires. These are not used.
2. Connect the black wire to ground.
3. Using a user supplied 3A fuse connect the red
wire to a positive 12 VDC source.
4. The flash patterns are selected by grounding
the programming wire (green). The flash patterns are as
follows:
a. Steady On
b. 120 FPM
c. 165 FPM
d. 240 FPM
e. 300 FPM
f. Combo 1:
4 intervals @ 120 FPM
10 intervals @ 300 FPM
g. Combo 2:
2 intervals @ 120 FPM
3 intervals @ 165 FPM
6 intervals @ 240 FPM
3 intervals @ 165 FPM
2 intervals @ 120 FPM
10 intervals @ 300 FPM
h. Combo 3:
1 interactive interval @ 120 FPM
2 intervals @ 120 FPM
6 intervals @ 240 FPM
14 intervals @ 480 FPM
6 intervals @ 240 FPM
2 intervals @ 120 FPM
1 interactive interval @ 120 FPM
290A5949
#8-32 X 1/2" HEX HEAD
MACHINE SCREW (2)
TOP CHANNEL
(SAME AS BOTTOM)
REAR CHANNELS
OPENING FOR HEX HEAD
MOUNTING SCREW (4)
