14
Installation and Maintenance Instructions
Model 371ST-250 Strobe Light
4.
Carefully remove the flash tube from its socket by grasping
the connector and lifting upwards using a slight rocking
motion.
DO NOT TOUCH LAMPS WITH BARE HANDS
Oil deposits on the glass portion of a strobe or halogen lamp can
cause the glass to fracture during use. If you are unsure whether
the glass portion has been handles without gloves, clean the
glass using a soft cloth and isopropyl alcohol before installing
the lamp.
5.
Install a new flash tube by fully seating it into the socket.
6.
Reassemble the light.
7.
Test the light to ensure it operates properly.
Cleaning the Dome
NOTE:
Maintenance procedures sometimes require fixtures to be
hosed down for good housekeeping. The electrical circuit should
be turned off prior to hosing down the light.
Clean the dome periodically to maintain maximum light output.
Use only mild, non-abrasive cleaning agents.
Getting Service, Assistance, and Parts
Federal Signal will service your product and provide technical
assistance and support. Please call the phone numbers listed below.
For instruction manuals and information about related products,
please go to http://www.federalsignal-indust.com.
Repair Service
Products returned for repair require a Return Authorization
form. To obtain service for the product, please contact the
Federal Signal Service Department at 708-534-4858.
Technical Assistance
For technical assistance, please call Technical Support at
708-534-3424, extension 5823.
